DESCRIPTION FEATURES SOFTWARE & COMUNICATION SUPPORT

 

 

DESCRIPTION:

The ETECNIC GARAGE charging stations feature an enclosure specially conceived for an on-wall installation, rather indoor than outdoor, and they have been designed to be used in public parking lots, hotels, shopping centres, private fleets, neighborhoods, etc.
These equipment present a current inlet Type 2 according to the IEC 62196-2 standard, allowing to charge in mode 3 (IEC 61851), guaranteeing a secure charging process. The mode 3 input features a cable retention and blocking system in order to avoid its disconnection from a non-authorised user.
In addition, the charging station has a domestic input to charge in modes 1 and 2. This input is limited to 10 Amps for security reasons.
The ETECNIC GARAGE charging station is available in both single and three-phase versions, with an output power ranging from 3.7 to 22 kW. In the event of a grid outage, the stations automatically recover their previous state, guaranteeing the correct ending of the charging process.
Thanks to their communication capacities, it is possible to identify the users and to charge them according to the established rate, by using a software from Ingeteam or from a third party.

 

FEATURES:

-Wall installation.
-Vehicle charging in modes 1, 2 and 3 (IEC 61851).
-Local identification through a RFID card.
-Power and energy measurement through a MID counter.
-Cable retention system along the charging process (Mode 3).
-Illuminated state indicator.
-Multi-language LCD display with keypad.
-Possibility of programming a deferred charging.
-Communication with other charging stations and Control Centres.
-It supports OCPP protocol.
-Anti-graffiti protection painting.

 

SOFTWARE & COMMUNICATIONS

The ETECNIC GARAGE charging station allows the interconnection with other stations from the INGEREV series by using a RS-485 protocol. Up to 10 stations can be enchained.
The addition of an Ethernet or GPRS/3G hardware makes it possible to remotely connect any station or integrate them into a Control Centre. The ETECNIC stations support the OCPP protocol and they can be integrated into most of the control systems of the electrical companies.
ETECNIC brings its clients at no extra cost the possibility of using a software to configure access and manage all the data coming from the charging stations. This software is the INGECON SUN Manager.

 

SUPPORT
In case of an incident with an ETECNIC GARAGE charging station, please contact our Technical Assistance Service at the telephone number 0034 977 276 952 or at the e-mail address soporte@etecnic.es

Software Updating
The ETECNIC GARAGE Basic’s software is very easily updatable, thanks to the use of a USB memory. You can download here the last software version for your equipment. Please contact with Etecnic if you would like to obtain an older version.
Download here the last Bootloader version.
Download the USB manual in order to proceed with an updating process.